Anti-Slip Paint
Anti slip polyurethane floor paint based on a high quality resin system with a very fine textured finish.
It is suitable for application to most surfaces and will provide a hard wearing, water and oil resistant finish, this product is ideal for general walkways, factory and garage floors.
Colours Available in 5lt cans:
*Important Note:
This product has anti-slip properties and therefore provides slip resistance, however, it is not possible to guarantee a totally non-slip surface.
Manufactured in the UK
Sealing / Priming:
It is only necessary to seal a porous substrate such as new or bare concrete. A sealer coat is achieved by adding 10% white spirit to the paint. Please note new concrete floors can only be painted after 6-8 weeks.
Area of use: Interior and exterior (not suitable for all exterior applications)
Substrates: Concrete stone and wooden floors
Colours: Red-04039 Green 14C39 Grey 00A05 Blue 20D45 and Black
Finish: Semi gloss
Volume solids: 50%
Theoretical spreading rate: 12 - 15 sq. metres per litre (depending on surface)
Flash point: 38°C
Specific gravity: 1.4
Dry to touch: 2 - 4 hours (20°C)
Over-coating time: 16 hours (do not exceed 5 days for over-coating)
Instructions
The Anti-Climb Paint is simply painted on.
FAQ
What tools are involved?
Do I need to replace any timberwork?
Do I need to strip any old felt off?
Does the roof need to be dry before installation?
What should I do if I get stuck during installation?
How do I make an order and how do I pay?
Q. Do I need any special tools to install the system?
A. No! You only need the usual DIY tools such as saw/screwdriver and hammer etc. There are no specialist tool required.
Q. Do I need to replace any timberwork?
A. No! Unless it's rotten or water damaged.
Q. Do I need to strip the felt off my roof before I start?
A. Only if your roof decking is soft or rotten as the system uses a geotextile breather underlay, which also has excellent thermal insulating qualities.
Q. Does the roof need to be perfectly dry before installation?
A. Your roof will never be perfectly dry as all flat roofs have a certain amount of water retention although the drier the better even though the rubber membrane breathes due to it being vapour permeable allowing you to install the roof with minimal fuss on a damp surface..
Q. What if I get stuck during installation?
A. No problem! Just give us a ring and we will talk you through the job step by step in simple terms We can also advise you how to install it as well as any other problems you may have. This advice is only at the cost of a phone call, there is no extra charge to you.
Q. How do I Order and how will I pay?
A. You can phone on 01793 435502 where you can order as well as get awnsers to any questions you might have.
.png)
